Connecting SAT cable with plug - how to do it

If your SAT cable or the associated plug is damaged, you need to replace them so that you can have perfect TV reception again. What to consider when replacing the cable and how to proceed correctly to reconnect the SAT cable to the plug, we explain in this article.

What to consider when connecting a SAT cable with the plug

A SAT cable, often referred to as an antenna or coaxial cable, is used to connect your satellite dish to your TV's receiver. If your old SAT cable or the connector is damaged or you need a longer cable for the connection, it is necessary to replace the cable. Before you can connect the new cable or plug, however, you will need to purchase a suitable cable or plug. While you can often get a plug for under 1 euro, a new cable is available from 6 euros.

How to connect a SAT cable with the plug

Once you have purchased the necessary material for the connection of SAT cable and plug, you can start to connect both parts. How you connect the new SAT cable to the plug in this case depends on what kind of plug it is.

1. If you have a screw or F-plug, it is first necessary to remove the protective cover of the SAT cable and pull back the insulation.
2. Then expose the copper wire of the cable by carefully cutting and pulling off the plastic cover and the shielding sleeve of the cable.
3. Screw the plug then on the end of the cable so that the copper wire protrudes slightly and cut off the protruding wire.